3/31/2024 0 Comments Astro saber flash code display![]() ![]() This section will try and answer many of those related questions. By the way, if you thing you can make yourself a cheap cable by just ordering part number A07, well, forget it. This cable is made up of the following parts. This cable is for the Astro Saber and Saber Si. Take a look at the programming cable for the Astro Saber. Note that it is the same as the one for the mobiles, except for the available power levels and the "H" at the beginning of the model number to denote portable. Here you can find the Astro Portable model breakdown chart. For keyloading, you use the same cable as a regular Saber, TKN, and the pinout is available here. The radio uses a third generation keyloader, there is a retro kit to upgrade the DES-XL key loader, and the data in and out pins are different. This causes problems since the center pin on the radio may not make contact and you will be transmitting into an open bad. ![]() There are some cheap adapters that have a recessed center pin on the female side. Be sure that you use a high quality adapter if you are going to convert from the SMA to something else. All these radios use a standard SMA connector for the antenna. ![]() Most of this information is for the Astro Saber, but since the XTS and its family are programmed by the same RSS, a lot of the information will be relevant for it too. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |